The cable tray should not be installed above the corrosive gas pipeline and heat pipe and below the corrosive liquid pipeline, otherwise, anti-corrosion and heat insulation measures should be taken. Therefore, the correct installation method should be followed in every step of installation.

電纜橋架中布線需注意：

Attention should be paid to the wiring in cable tray:

1.電纜橋架布線時，電纜不應有黃麻或其他易延燃材料外護層。

1. When cable tray is used for indoor wiring, the cable shall not be provided with jute or other flame retardant materials.

2.在潮濕的場所或防腐蝕地方采用電纜橋架布線時，應根據不同采取相應的防護措施，并宜選用塑料護套電纜。

2. When cable tray is used for wiring in wet places or anti-corrosion places, corresponding protective measures should be taken according to different conditions, and plastic sheathed cables should be selected.

3.電纜橋架安裝時的距地高度一般不宜低于2．50m，垂直安裝時距地1．80m以下部分應加金屬蓋板保護，但敷設在電氣專用房間（如配電室，電氣豎井、技術層等）內時除外。

3. The height of cable tray from the ground should not be less than 2.50M during installation. When installing vertically, the part below 1.80m above the ground should be protected by metal cover plate, except when it is laid in special electrical room (such as distribution room, electrical shaft, technical layer, etc.).

4.電纜橋架水平安裝時，宜按荷載曲線選取跨距進行支撐，跨距一般為1．5～3m。垂直敷設時，其固定點間距不宜大于2m。

4. When the cable tray is installed horizontally, the best span should be selected according to the load curve, and the span is generally 1.5-3m. When laying vertically, the spacing between fixed points should not be greater than 2m.

5.幾組電纜橋架在同一高度平行安裝時，各相鄰電纜橋架間應考慮維護、檢修距離。

5. When several groups of cable trays are installed in parallel at the same height, the maintenance and overhaul distance between adjacent cable trays shall be considered.

6.在電纜橋架上可以無間距敷設電纜，電纜在橋架內橫斷面的填充率：電力電纜不應大于40％；控制電纜不應大于50％。

6. The cable can be laid on the cable tray without interval. The filling rate of the cable in the cross section of the cable tray: the power cable should not be greater than 40%; the control cable should not be greater than 50%.

7.下列不同電壓，不同用途的電纜，不宜敷設在同一層橋架上：

7. The following cables with different voltages and different uses should not be laid on the same layer of bridge:
相關標簽：濟南電纜橋架